How To Attach Bathroom Sink To Wall

If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge.

How to attach bathroom sink to wall.

Follow manufacturer s directions for the size and depth of. Mount the sink to the wall. The valves are typically under the sink. The pockets are not deep enough for the tabs on my sink the holes do not align etc.

Prepare the faucet drain and pop up. Ideally i would like to mount the sink using only the two rear tabs bolted to the wall. Drill pilot holes into the wall at the marked locations. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain.

The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets. Check the level again before trimming the shims with a utility knife. If the holes are not completely lining up or you want a more. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink.

Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. Turn off the water supply. Measure and mark the location of the sink on the wall again. Attach the sink 1.

Loosen the slip nut at the top of the p trap. Attach the vanity to the wall using 3 inch drywall screws. Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes. Be sure to use a masonry.

Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it. Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall. Drill your pilot holes for the lag screws which should be included with your wall mount sink. This metal or plastic nut will be located either in the wall or the floor.

If not turn off the water at the main valve. Have a small bucket ready to catch any water. Lift the back edge of the sink onto the bracket. Verify the toggled wings open once you.

Lift the sink slightly while tightening the nuts with a wrench. Remove the entire trap if necessary. Two on the rear against the wall and one on each side. Use plumber s putty as you attach the.

Use the template that comes with the sink to mark the. Use your hands or locking pliers to unscrew the nut. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Locate the large nut that connects the sink to the drain and disconnect it.